Tuesday, October 22, 2019

Plumbing Grand Prairie TX Pro

https://www.facebook.com/PlumbingforGrandPrairie/

Business Name : Plumbing Grand Prairie TX Pro 🤝

Tel: 469-290-4381 📞

How to Turn on a Water Heater

Making Sure the Water Tank is Full

1- Shut off the water provide and gas valve or circuit breaker.

2- Drain and flush the tank to easy it out.

3- Shut the drain valve whilst maintaining the water provide open.

4- Keep checking the nearby open hot water tap.

5- Turn on the gas provide or circuit breaker.

Monday, October 7, 2019

Plumbing Grand Prairie TX Pro

Plumbing Grand Prairie TX ( How to Repair a Noisy Toilet )
Plumbing Grand Prairie TX  

Reducing Noise When the Toilet Fills
Link : https://plumbing-grandpraire.com/
Phone : 469-290-4381

https://www.facebook.com/PlumbingforGrandPrairie/

 1- Assess the water flow pressure into the tank. If the water pressure is too high or too low, it can create noise in the water flow valve. In order to assess the water pressure of the water coming out of the fill valve, pull off the refill hose right where it connects to the fill valve. Be careful, as water will be flowing if this is done while the toilet is filling.
• If there is a strong stream of water coming out, then the water pressure may be too high. If this is the case, try turning the water valve at the base of the toilet partly down, reattach the hose, and try flushing again. The lowered pressure may eliminate the noise.
• If the water pressure into the toilet is very low, then you will need to increase it. This will require you to investigate the fill valve a little further

 
https://www.facebook.com/PlumbingforGrandPrairie/


2- Clean out the fill valve. If the water pressure is too low, it may be restricted while it goes through the fill valve. In order to assess this, you will need to take the top of the fill valve off and clean it out. First, turn off the water to the toilet. Then, take the top of the fill valve. Look for debris that could be impacting the water pressure.
• To clean out the valve you will need a large cup that you can hold over the top of it. With the top of the valve off, place the cup over the top and turn the water back on for a few seconds. The water should shoot up into the cup, taking all debris and gunk that was in the valve with it. Then, turn the water off and replace the valve cap.



https://www.facebook.com/PlumbingforGrandPrairie/

3- Replace the fill valve if necessary. If you have cleaned out your fill valve and it is still making a lot of noise when the toilet tank fills, then you may need to replace it. Turn the water to the toilet off and then drain the tank by flushing the toilet. Remove the existing fill valve and take it with you to your local home improvement or hardware store.
• By having the existing fill valve with you, you can be sure to get a replacement that will fit your toilet.
• Ask an employee at the store to help you if you are unsure how to find the right part.
• Take the replacement part home and follow the instructions it comes with to install it correctly.



 
electrical_water_heater 
plumbers_near_me      
hot_water_heater
electric_water_heater 
plumbing_services 
emergency_plumber 
water_heater_repair 
Water_heater_installation 
commercial_plumber 
residential_plumber
commercial_plumbing
Water_Heater_Grand_Prairie_TX 
Plumbing_Grand_Prairie_TX

Plumbing Grand Prairie TX

+ Plumbing Grand Prairie TX 💪 🤝 https://plumbing-grandpraire.com/ Tel: 469-290-4381 📞 How to Clean a Drain Pipe ? # plumbers_nea...